At a glance. An outdoor sculpture is a special structure, and wind is often the governing load case. Large forms, broad wind-facing areas and rooftop positions behave less intuitively than they look. This guide covers the load concepts, structural options and connection details.
Why wind tends to govern
Wind pressure grows roughly with the square of wind speed, so it escalates quickly. A small, heavy sculpture may need a very high wind speed to move, but on a high roof, in open ground or at a wind funnel, local speed can be far above ground level, and slender or cantilevered forms amplify the effect. Beyond speed, the projected area, shape coefficient and height factor all change the result. Pierced or screen-like forms present less solid area, yet individual members can see concentrated local loads; slender members may also experience vortex-induced cross-wind oscillation, which is a dynamic problem distinct from static pressure.
Separate the skin from the structure
The outer shell - stainless sheet, FRP, copper - encloses and gives form. Real load capacity comes from an internal steel armature tied reliably to the foundation, transferring wind and self-weight into the ground or primary structure; the shell should never be asked to carry itself structurally. Common armature forms are a cantilever column, a space truss and a fitted frame. A cantilever is simple and suits small-to-medium work; a space truss gives the stiffness and stability needed for large complex forms; a fitted frame follows the shape closely but has many nodes, each needing individual checking. Balance structural efficiency against what the form allows.
Connections and foundations
Nodes are the weak links. Base-plate anchors must be designed for combined tension, shear and pull-out including the tensile stress from overturning moment, with bolt size, embedment and edge distance to code. Protect the steel-to-concrete interface against corrosion and water, because rust silently reduces anchorage capacity. Foundation design covers bearing capacity and overturning: self-weight or tension piles resist the moment induced by wind. Cast-in plate position directly affects installation accuracy, so recheck location and level before pouring and allow adjustment - forcing a correction on site damages the structure.
Calculation, testing and acceptance
A qualified structural engineer should produce the load calculation and member check, with a written calculation sheet stating design wind speed, shape factor and safety factor. Large or unusual forms may justify wind-tunnel testing or numerical wind simulation to get a realistic pressure distribution. At handover, verify material specification, weld quality and corrosion protection, with particular attention to concealed connections: visual inspection of welds as a minimum, non-destructive testing at critical nodes. Check verticality and overall deformation after installation, and where appropriate measure the response under wind.
Modifications and height increases need the same review. Adding height increases wind load disproportionately and the existing foundation and armature may no longer comply. Obtain the original structural documents; if they are unavailable, establish capacity by survey and testing before choosing between strengthening and rebuilding. Do not proceed on experience alone.
From the workshop
How we work
The seven-step process from brief to crated delivery, plus how quotations are built.
Read process →Export & terms
Packing, documentation, freight terms and what an overseas buyer needs to confirm.
Read terms →Three ways into the material
Technique articles explain how the work is made. Buyer insights explain how a project is specified, approved and accepted. The Q&A section answers the questions that come up before a quotation is agreed.
Technical knowledge base
22 in-depth articles on materials, processes, installation QA and applications.
Open section →Buyer insights
7 long-form guides on contracts, site access, acceptance, briefing and aftercare.
Open section →Tell us what you are building
Send photos, dimensions, the destination country and your target date. You will get a technique recommendation, a reference price band and a production schedule - no obligation.
Request a quoteHow export works