At a glance. Cracking in gypsum relief is a frequent quality issue with causes spread across mix proportions, substrate condition, structural fixing and curing. Repairing afterwards rarely holds. This guide follows the construction sequence.
Water-to-gypsum ratio and additives
The water ratio governs both strength and shrinkage. Too much water lowers strength and increases drying shrinkage, producing fine crazing; too little gives poor flow and leaves voids and weak spots in the mould. Use measured containers rather than judging by feel, and mix until no dry lumps remain. Retarder buys working time but an overdose clearly reduces strength; fibre improves toughness only if it is evenly dispersed, since clumped fibre becomes a stress concentrator. High-strength gypsum or a dedicated reinforcing admixture is appropriate for heavily loaded elements.
Substrate and thickness control
An uneven or moving substrate loads the relief unevenly and pulls it apart through temperature cycles. Level and confirm stability first; timber bases need controlled moisture content and a damp barrier so they do not swell and jack the finish off. Large continuous runs need movement or control joints to release stress deliberately. Within the relief, avoid abrupt thickness changes - the transition is where cracks start - so ease the transition in the shop drawing, add thickness or ribs at returns, and split oversized panels into manageable pieces for transport and assembly.
Fixing and structural connection
Small pieces can use a dedicated adhesive combined with mechanical fixing; large pieces need a framing system or cast-in anchors that carry the self-weight into the structure, never adhesive alone. Using both is the safer specification. Where metal framing meets gypsum, allow a flexible transition - elastic pads or a flexible joint - because differential thermal movement otherwise accumulates into a crack. Fixing centres need to be neither so wide that the panel sags nor so tight that restraint cracking appears.
Curing, repair and acceptance
After forming, gypsum needs ventilated drying without rapid drying or cold draughts; fast water loss is a common cause of early cracking. Keep vibration and load off during curing, and only sand and coat once strength has stabilised and moisture is within limit. Hairline cracks can be filled with gypsum filler or an elastic jointing compound, but a wide structural crack must have its stress source removed first or it returns.
Inspect before painting, recording any through-cracks, hollow spots and deformation. Also manage the environment: concurrent wet trades swing the humidity, and winter heating or summer air conditioning blowing directly on a fresh face creates local over-drying. Control ventilation during curing and, if needed, sheet the surface to slow water loss.
From the workshop
How we work
The seven-step process from brief to crated delivery, plus how quotations are built.
Read process →Export & terms
Packing, documentation, freight terms and what an overseas buyer needs to confirm.
Read terms →Three ways into the material
Technique articles explain how the work is made. Buyer insights explain how a project is specified, approved and accepted. The Q&A section answers the questions that come up before a quotation is agreed.
Technical knowledge base
22 in-depth articles on materials, processes, installation QA and applications.
Open section →Buyer insights
7 long-form guides on contracts, site access, acceptance, briefing and aftercare.
Open section →Tell us what you are building
Send photos, dimensions, the destination country and your target date. You will get a technique recommendation, a reference price band and a production schedule - no obligation.
Request a quoteHow export works