At a glance. One route shapes cement on site, the other casts it in a factory. Freedom, consistency, programme and cost move in different directions. This guide explains the trade so the process is chosen before it creates rework.
What direct modelling does well
Direct modelling builds the form onto the substrate with mortar or a cement-based material over a steel armature or wire mesh, layer by layer, like additive sculpture. Its great advantage is freedom: proportions and detail can be changed as the work progresses, which suits irregular, nature-like forms and pieces that must fit existing site conditions exactly. The weakness is dependence on site conditions and the individual craftsperson. Temperature, humidity, curing and technique all affect strength and finish, and each layer needs a setting interval, so the programme is long.
What precast does well
Precast components - GRC, precast concrete, cast art pieces - are moulded in a factory where mix, compaction and curing are controlled, giving noticeably better strength and surface consistency. It suits repeated, higher-volume elements such as balustrades, mouldings, cladding panels and standardised forms. The limits are mould amortisation and logistics: the more unique the form, the worse the mould cost per piece; the larger the piece, the more transport and lifting constrain it, and splitting it into panels makes joint treatment the quality focus.
The comparison that matters
Precast wins on consistency, direct modelling on freedom. For small urgent runs, modelling can be faster; for large repeated runs, precast wins on programme. Cost crosses over at some volume: modelling is labour-heavy with no mould fee and is cheaper in small quantities, while precast carries a mould fee but its unit cost falls with quantity. Durability depends more on the material system than the forming route - reinforcement, fibre, compaction and cover depth are what matter - though on-site compaction is harder to guarantee and needs layered compaction plus full curing to compensate.
Selection and the route in between
Check repetition first, then volume and programme. Unique, medium-scale work that must fit the site closely points to modelling; standardised, repeated work with a consistency and programme requirement points to precast; a hybrid uses modelling for the main form and precast for standard parts. Either way, bring shop drawings forward: modelling needs its armature and loads calculated, precast needs panel splits and the lifting path fixed. Deciding the process during construction is what causes misplaced cast-in items and rework.
Do not overlook mould-cast on-site work: a clay original is modelled, a mould taken from it, and the final piece cast in cement or resin. It sits between the two routes - more precise than direct modelling, freer than standard precast - and is often the right answer for complex forms with a modest run.
From the workshop
How we work
The seven-step process from brief to crated delivery, plus how quotations are built.
Read process →Export & terms
Packing, documentation, freight terms and what an overseas buyer needs to confirm.
Read terms →Three ways into the material
Technique articles explain how the work is made. Buyer insights explain how a project is specified, approved and accepted. The Q&A section answers the questions that come up before a quotation is agreed.
Technical knowledge base
22 in-depth articles on materials, processes, installation QA and applications.
Open section →Buyer insights
7 long-form guides on contracts, site access, acceptance, briefing and aftercare.
Open section →Tell us what you are building
Send photos, dimensions, the destination country and your target date. You will get a technique recommendation, a reference price band and a production schedule - no obligation.
Request a quoteHow export works